CPAP Resmed AirStart 10 AutoCap
Contact Us : +91-9810016599
The ResMed AirStart 10 with HumidAir is one of the newest devices in ResMed’s Air series. It is an effective, low-cost, and basic device. It is simplistic to use for most users, and with all the basic features you’d expect in a premier CPAP machine, you will rest easy knowing you’re getting outstanding quality. Equipped with a vibrant LCD display, you will have no trouble seeing at night and you will enjoy the accessibility of each setting. Another benefit is the light weight; as it is only 2.75 pounds, you have the flexibility to travel without all the unnecessary weight other machines often require. It is a great travel companion.
The AirStart is built on the idea of simplicity. Due to its basic design, this device is looking to target users in need of a second machine in the event of frequent travel.
EPR is an algorithm that works by decreasing the pressure at the beginning of each breath a user takes, and then subsequently limiting that pressure throughout exhalation.
The new HumidAir humidifier features a slightly larger water chamber capable of holding up to 380 mL of water. The humidifier will help reduce some of the negative symptoms of CPAP by propelling warm, moist air into your lungs. If you wish not to have humidified air may opt to remove the humidifier from the machine entirely or simply not fill the water chamber.
The ramp feature has been redesigned to help make sleep even more comfortable. In the ResMed AirStart 10 CPAP, you can still use the ramp to gradually increase pressure over a 45 minute interval. This will allow you to fall asleep without any incoming pressure, helping you fall asleep naturally.
No complicated menus or settings. On the display screen, the user is given the ability to change any settings deemed needing to be changed such as ramp time, humidity level, or EPR.
| Height | 116 mm |
|---|---|
| Weight | 1106 gm |
| Breadth | 205 mm |
| Length | 150 mm |
| Sound pressure level | 26.6 dBA with uncertainty of 2 dBA as measured according to ISO 17510-1:2009 (CPAP mode) |
| Modes | CPAP, APAP |
| Sound power level | 26.6 dBA with uncertainty of 2 dBA |
| Peak power consumption | 104W (108VA) |
| Operating pressure range | 4–20 cm H2O |
| Supplemental oxygen Maximum flow | Recommended maximum flow: 4 L/min |
| Power supply unit | 90W power supply unit |
| Storage and transport humidity | 5 to 95% relative humidity, non-condensing |
| Storage and transport temperature | -20°C to +60°C |
| Operating humidity | 10 to 95% relative humidity, non-condensing |
| Housing construction | Flame retardant engineering thermoplastic |
| Air outlet | 22 mm air outlet complies with ISO 5356-1:2004 |
| Typical power consumption | 53W (57VA) |
| Sensors | Pressure sensor: Internally located at device outlet, analogue gauge pressure type, -5 to +45 cm H2O (-5 to +45 hPa) Flow sensor: Internally located at device inlet, digital mass flow type, -70 to +180 L/min |
| Operating altitude | Sea level to 2,591 m; air pressure range 1013 hPa to 738 hPa |
| Operating temperature | +5°C to +35°C |
| Maximum single fault steady state pressure | Device will shut down in the presence of a single fault if the steady state pressure exceeds: 30 cm H2O (30 hPa) for more than 6 sec or 40 cm H2O (40 hPa) for more than 1 sec. |
